Pinstripe Pedals | MBFR | High-End Buffer & Signal Splitter | w/ Jensen Transformer
or 4x fortnight payments of
$74.75 AUD
with
ⓘ
High-quality, high current buffer/signal splitter for use in multiple scenarios. It is powered by normal (Boss-style) pedalboard-friendly 9Vdc from any supply (no special adapters needed). The jacks are oriented specifically to integrate with your other pedals (fits easily on your board). Uses a genuine Jensen Transformer for the cleanest, clearest signal and the greatest noise rejection.
High input impedance TS input. Output 1 is a low impedance TS output. Output 2 uses the same buffer as output 1 but adds a Jensen line isolation transformer to allow ground lift and Polarity Reverse functions. This is useful when combining two amplifiers for greater tonal effect. Output 2 is on an isolated 1/4 inch Switchcraft jack that can be used in either a TS or TRS configuration.
Output 2 can be used as an active DI for recording and allows for balanced connection via TRS or using a TRS to XLR adapter (available separately)
All-metal connectors from Switchcraft. High-quality, sealed switches from Grayhill. Handbuilt in Oklahoma USA
Power: 9Vdc, 20mA draw
Max In/Out Level: >5Vrms
Noise: 2 microVolts, 110dBu, A-weighted
THD (Distortion): <0.0007% (Bandwidth limited at 20kHz), with 150Ohm load
Input: 1/4 inch, high impedance (1 Megaohm)
Out1: 1/4 inch, low impedance (47 Ohms) buffered, Frequency Response (+0, -0.5dB): 10Hz to 200kHz
Out2: TS/TRS 1/4 inch buffered and isolated, Frequency Response (+0, -1dB): 10Hz to 200kHz
- Jensen Transformers line isolation transformer for the best tone
- Ground Lift Switch to kill hum noise
- Polarity Flip switch to invert the signal to the amp 2 when needed
- Can be used as an active DI for recording (with adapter)