Earthquaker Devices | Night Wire V2 | Wide Range Harmonic Tremolo

Hey champ! Welcome to your brand new Night Wire! The Night Wire is a feature-rich harmonic tremolo. What is harmonic tremolo? In short, the signal is split into high pass and low pass filters, then modulated with an LFO that is split 180 degrees. The Night Wire takes the traditional harmonic tremolo a few steps further by allowing the centre point of both filters to be adjusted for different tones. The filter frequency has three modes: Manual, LFO and Attack.

In Manual mode, the centre point can be set to a fixed position with the frequency control. In LFO mode, the filters are continuously swept and the frequency control adjusts the speed. In Attack mode, the filters are dynamically swept according to pick attack and the frequency control acts as a range control, much like a standard envelope filter. The tremolo section has two modes, Manual and Attack. In Manual mode, the speed of the tremolo is governed by where the rate control is set. In Attack mode the speed is controlled by pick attack and the rate controls the sensitivity; the harder you pick, the faster the rate and vice-versa. The tremolo can be subtle and shimmery or full-on throbbing depending on where the depth control is set. With the depth set to zero, the Night Wire will act like a fixed filter, phase shifter or envelope-controlled filter depending on which mode the filter frequency is in. It also features a cut/boost volume control to get your levels just right.

Each Night Wire is hand made one at a time in the moonlit village of Akron, Ohio.

Features

• Dynamic harmonic tremolo
• Filter section has 3 selectable modes
• In Manual mode the centre point is controlled by the "Frequency" knob
• LFO mode sweeps the filter continuously with "Frequency" adjusting speed
• Attack mode sweeps the filter according to pick attack and "Frequency" adjusts sweep range
• Tremolo has 2 modes
• Manual mode means speed is governed by the "Rate" knob
• In Attack mode speed is controlled by pick attack
• Flexi-Switch™ allows you to simultaneously use momentary and latching style switching
• Switching is relay based, it requires power to pass signal
• Uses standard 9 volt DC power supply with a 2.1mm negative centre barrel
• Hand made in Akron, Ohio.
• Current Draw: 78ma
• Input Impedance: 1M
• Output Impedance: <1K